All projects
Build

Build a cedar raised bed with a drill and a saw

A 4 by 8 bed from cedar boards, put together with screws and corner blocks. No fancy joinery and no power saw needed.

Difficulty
Weekend project
Time
A weekend
Season
Spring

Posted

Build a cedar raised bed with a drill and a saw

Potting Bench Notes

Tools and materials

Build a cedar raised bed with a drill and a saw

Tick things off as you gather them.

Four feet wide means you can reach the middle from either side without stepping on the soil. Eight feet long uses the boards with almost no waste.

  1. Cut two of the boards in half to make four 4 ft ends.
  2. Screw the first long board and an end board to a corner block, keeping the tops flush. Repeat at each corner.
  3. Add the second row of boards above the first, onto the same corner blocks.
  4. Set the frame where it gets the most sun, check it's level, and dig the low side down rather than packing up the high side.
  5. Line the bottom with cardboard to smother the grass, then fill with a mix of soil and compost.

Filling it cheaply

Put logs, branches and old leaves in the bottom third. They rot down slowly and you need much less bought soil.

Get the next project in your inbox

One email when a new project goes up on Potting Bench Notes, with what it takes and a link to the materials list.

Potting Bench Notes

New projects by email

Leave your email to hear about new projects: things to plant, build, fix and paint, each with its materials list.

A question about a project? Write to hello@pottingbenchnotes.com